A workshop turnover warehouse cage is a fairly common turnover tool. It has a foldable design, a metal structural frame, a high load capacity, and a welded build, so it lasts a long time in normal service. Common sizes are the A-3, A-5, and A-7 warehouse cages; non-standard units can be designed and built to the workshop's actual dimensions and the goods' characteristics. Its use in the workshop is flexible: it holds raw materials, semi-finished goods, and flows between process steps. When idle, the four mesh panels fold down onto the base and stack out of the aisles. If the workshop floor is flat and the cage moves often, caster wheels can be added to the bottom to make a turnover trolley. If the cage goes on racking, do not fit wheels - instead fix it with square tube or angle iron supports. Xintongnuo's advice: when selecting for a workshop, measure the aisle width and door height first, then compare them against the outer sizes of the A-3/A-5/A-7, so the cage does not arrive and fail to fit through the door.